Water Outlet - Hartmann DS6 Instruction Manual

How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the excess water in hoses cann ot be drained dire ctly
into the sink. It will be necessary to drain excess water from hoses into a bo wl o r suitable
container that is held outside and lower th an the sink.

Water Outlet

Connect the water drain hose. The drain hose mu st be correctly fitted to avoid water leaks.
Ensure that the water inlet hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
Syphon Connection
The waste connection must be at a height of be tween 40 cm (minimum) and 100 cm (maximum)
from the bottom of the dish. T he water drain hose should be fixed by a hose clip.
The following things should be checked before starting the dishwasher.
1
The dishwasher is level and fixed properly
2
The inlet valve is open
3
There is a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
The inlet and drain hoses are knotted
7
All packing materials and printings should be taken out from the dishwasher
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.
15