Index Search; Next Function Memory; Instant Review; Tape Position Indicator - JVC FST-GTK2I HR-J240E Instructions Manual

10
EN

Index Search

Your recorder automatically marks
index codes at the beginning of
each recording. This function gives
you quick access to any one of 9
index codes in either direction.
NOTE:
Before starting, make sure the
recorder is in the Stop mode.
ACTIVATE INDEX SEARCH
1
Press PUSH JOG
control. "™ 1" or "£ 1" is displayed on screen
and search begins in the corresponding direction.
To access index codes 2 through 9, press PUSH JOG
or repeatedly until the correct index number is
displayed.
Ex.: To locate the beginning of B from the current
position, press PUSH JOG twice.
To locate the beginning of D from the current
position, press PUSH JOG
When the specified index code is located, playback
begins automatically.

Instant ReView

Simply by pressing a single button, the recorder power comes
on, rewinds, and begins playback of the last timer-recorded
programme. If you have several programmes recorded, you can
easily access any of them.
NOTE:
Before starting, make sure that the recorder is off and that the
Timer mode is disengaged.
ACTIVATE INSTANT
REVIEW
1
Press REVIEW. The recorder power comes on and the
recorder searches for the index code indicating the start
of the last timer-recorded programme. Once it's found,
playback begins automatically.
The front display panel tells you how many programmes
have been recorded. If you have, for example, 3
programmes, "REVIEW" and "3" appear and blink. To
watch the first of the 3 programmes, press REVIEW three
times. The recorder searches and begins playback
automatically. You can access a programme as far as 9
index codes away from the current tape position.
NOTE:
Instant ReView is not possible while the recorder is in the Timer
mode.
or (™ or £) on the remote
once.
Current position
A B C D E F
–2 –1 1 2 3
Index number

Next Function Memory

You can set your recorder's power to go off automatically after
£ 2
the tape is fully rewound. Before starting, make sure the
recorder is in the Stop mode.
For Automatic Power Off After Tape Rewind . . .
. . . press REW, then press
NOTE:
If you want the power to be turned off automatically when the
counter reads "0:00:00" (instead of at the beginning of the
tape), press C. MEMORY so that the "M" mark appears before
pressing REW.
Counter Memory
Returns to the counter reading of "0:00:00" to conveniently find
a specific place on the tape automatically.
SET COUNTER MEMORY
1
Press C.(COUNTER) RESET during playback at a point
you wish to locate later. The counter reads "0:00:00".
Then press C.(COUNTER) MEMORY, and "M" appears
in front of the counter digits.
ACTIVATE COUNTER
MEMORY
2
When you wish to return to the designated point, press
STOP and then REW or FF.
The tape rewinds or fast-forwards and stops at about
0:00:00 automatically.
To cancel Counter Memory, press C.(COUNTER)
MEMORY again.

Tape Position Indicator

The tape position indicator
appears on screen when, from
the Stop mode, you press FF,
REW or perform an Index
Search. The position of "5" in
relation to "0" (beginning) or
"+" (end) shows you where you
are on the tape.
"O.S.D." (
set to "ON", or the indicator
will not appear.
NOTE:
Depending on the type of tape used, there may be times when
the indication is not correct.
PLAYBACK (cont.)
within 2 seconds.
0
pg. 14) must be
Beginning
3
+ + +
1:23:45
End