General; Warning Messages; Error Messages - JVC LST1153-001A Instruction Manual

General

Warning Messages

To prevent operational errors, the LCD display shows one of the following warning messages when an erroneous operation is
performed.
Displayed Message
INVALID ENTRY
GAIN : LOLUX
INVALID ENTRY
FULL AUTO : ON
INVALID ENTRY
GAIN : ALC + EEI
INVALID ENTRY
GAIN : ALC
INVALID ENTRY
W.BAL : FAW
INVALID ENTRY
W.BAL : PRESET
INVALID ENTRY
W.BAL : MANUAL
INVALID ENTRY
BARS : ON

Error Messages

When the LCD display shows one of the following error messages during an auto white balance adjustment and Auto Set mode,
check Cause and Check Point below and then retry the auto white balance adjustment. (The error message is displayed for
about 5 seconds.)
Displayed Message
AUTO WHITE A (B)
ERROR: LOW LIGHT
AUTO WHITE A (B)
NG: OBJECT
AUTO WHITE A (B)
ERROR: OVER LIGHT
AUTO BLACK LENS NOT
CLOSED?
AUTO BLACK ERROR!
Cause
The gain is set to the Lolux mode.
The [FULL AUTO] button is ON.
[ALC + EEI] is ON .
[ALC] is ON .
The white balance is set to the FAW
mode.
The [W. BAL] button is set to
PRESET .
The white balance adjustment is set to
manual mode by the [WHITE-AUTO]
button.
The [BARS] button is pressed.
Cause
The light intensity is insufficient.
The object is not suitable for shooting. Check if the object is white and change the object if required.
The amount of incident light is too
high.
The color temperature conversion filter
is not set properly.
The lens will not close for auto black-
balance adjustment.
Auto black adjustment is not working
properly.
Check Point
Exit from the Lolux mode, and then adjust the gain again.
Press the [FULL AUTO] button so that the lamp in it turns off, then retry
operation.
Exit from the [ALC + EEI] mode, and then retry operation.
Exit from the [ALC] mode, and then retry operation.
Cancel FAW and start the white balance adjustment.
Auto white balance adjustment cannot be started in this mode.
Auto white balance adjustment cannot be started in this mode.
Press the [BARS] button so that the lamp in it turns off, then retry
operation.
Check Point
Increase the lighting (illumination) or boost the gain with the [GAIN]
button.
(Note that the sensitivity deteriorates when the gain is boosted.)
Check if a strong light source, such as the sun, is shining into the
camera either directly or as a result of a reflection caused by the
object.
Set the color temperature conversion filter to the correct position.
Set the camera so that the lens can be closed.
Check the setups of the RM-HP790DU/RM-HP790DE and camera
again.