9.16. Remove the Woofer
1. Unlock the cable clampers to free the cable.
2. Disconnect the Relay connector.
3. Remove the screws (×4
9.17. Remove the Stand bracket
1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
2. Unlock the cable clampers to free cable.
3. Remove the Stand bracket fastening screws (×6
) and the Stand bracket.
) and remove the Woofer.
, ×4
9.18. Remove the K-Board
1. Remove the SP shield metal L. (See section 9.15.)
2. Remove the Stand bracket. (See section 9.17.)
3. Remove the screw (×1
4. Remove the claws (×3
5. Disconnect the connector (K1) and remove the K-Board
from the LED panel.
9.19. Remove the S-Board
1. Remove the SP shield metal L. (See section 9.15.)
2. Remove the screws (×2
3. Disconnect the connector (S10) and remove the S-Board.
9.20. Remove the V-Board
1. Remove the SP shield metal R. (See section 9.15.)
2. Remove the Stand bracket. (See section 9.17.)
3. Remove the screw (×1
).
4. Disconnect the connector (V14) and remove the V-Board
from the 3D emitter panel.
31
).
).
).
) and remove the claws (×3