Advertisement
Installation instructions - Free-standing model
1
produce dimensions
600
850
( All sizes are given in millimetres)
850mm H x 580mm D x 600(or 450)mm W
We reserve the right to make technical
modifications.
4
Inlet pipe connection
3/4"
1/2"
MIN 10 mm
P=30-1000KP
3/4"
3/4"
5
Drain pipe connection
DISHWASHER
POWER
OUTLET
Drain pipe connector
Inlet pipe
connector
FRONT VIEW
Min 100mm
Insert the drain hose into the drain pipe and fixed properly with a clamp . Make
sure thereis no bending on the drain pipe ( You may use the special plastic
support that attached with the appliance).The free end of the hose must be
at a height between 400 and 1000mm and must not be immersed in water.
6
Insert the plug
POWER OUTLET
The first time you use the dishwasher , check the water inlet hose and drain hose for leaks.
2
SINK
The plug must be plugged into an appropriate
outlet that is installed and grounded in accordance
with all local codes and ordinances.
T urn
During levelling ,unplug the appliance from the mains.
Once the appliance is positioned , adjust the feet
(screwing them in or out) to adjust the height of the
dishwasher, making it level. In any case ,the appliance
should not be inclined more than 2 .
Connect the cold water supply hose to a threaded 3/4(inch)
connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an
extended period of time, let the water run to make sure that
the water is clear and free of impurities. If this precaution is
not taken, there is a risk that the water inlet can get blocked
and damage the appliance.
The water supply to the appliance can also be connected to the
house hot water line (centralized system, heating system),as
long as it does not exceed a temperature of 60 °C.
In this case, the wash cycle time will be shortened by about 15
minutes and the wash efficiency slightly reduced.
The connection must be made to the hot water line following the
same procedures as those for the connection to the cold water
line.
1
3
BACK VIEW
Drain pipe
connector
°
SINK
POWER
OUTLET
Min 100 mm
NOTE :
Please refer to above picture, if you want
to install the dishwasher at the right side
of the sink.
Inlet pipe
connector
DISHWASHER
Drain pipe connector
Inlet p i pe connector
Min 100mm
FRONT VIEW
Advertisement
