Kensington keyboard for iPad 3 Quick Start Manual page 4

For ipad 3
Table of Contents

Advertisement

3
Press the On/Off Switch for 3 to 8 seconds. The Power Indicator Light
NOTE: When you first turn on the Keyboard, both the Power Indicator Light and the
Bluetooth Status Indicator Light glow for 5 seconds. You cannot connect the Keyboard to
your iPad until only the Power Indicator Light glows.
4
On your iPad, tap Settings.
5
Open Bluetooth and make sure Bluetooth is on.
6
On the Keyboard, press the Bluetooth Connection Button. The Bluetooth Status
Indicator Light starts blinking for 10 minutes or until connected to a device.
7
The Keyboard now appears on your iPad screen. Tap Bluetooth Wireless Keyboard.
8
Your iPad screen displays a passkey. Enter the passkey on the Keyboard, and press Enter.
9
Your iPad screen shows the Keyboard as Connected. On the Keyboard, the Bluetooth
Status Indicator Light turns off.
10 You can now use your Keyboard to type in any app.
NOTE: To insure the K Lock key works correctly please ensure you do the following:
Home page > Settings > General > Passcode key. Verify "Require Passcode" is set to
"Immediately" otherwise a keyboard unlock will not require a passcode. Go back to
previous menu and verify "Passcode Lock" is On.
Note the following about the Bluetooth connection between the keyboard and your iPad:
• Keyboard will go into pairing mode if the On/Off Switch press for 8 seconds or longer
then release (regardless of on or off state).
• Press the On/Off Switch for 3 to 8 seconds then release = toggle keyboard power (on
to off, off to on).
• First turn (Factory default, no prior paired BT devices) – enter pairing mode
automatically.
• In ON state only - Hold "CTRL + ALT + FN + F" for 3 seconds or more = reset to factory
default mode (clear all previously paired BT devices in memory), ALL LEDs should flash
on and off 3 times and keyboard should turn to off mode.
• If no active key press for 1 minute, the unit should go to sleep mode.
• Anytime a key is pressed in sleep mode, the keyboard should automatically connect to
last paired iPad if present. If iPad is not found after waking from sleep mode within 30
seconds, the device should go back to sleep.
4
glows.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Keyfolio expert k39532usKeyfolio m01147Keyfolio expert

Table of Contents