Puch Magnum X User Manual page 20

and remove carburetor from intake manifold. Remove re-
strictive orifice (fig. B/2) from intake manifold. When mounting
carburetor note that the float chamber (fig. 8/3) is vertical.
Thereafter, if you intend to throttle the MAGNUM X again, use
a new filter part no. 362.1.15.040.2. If, however, you do not
intend to throttle the machine again, remove the metal plate
(fig. A/2) from the filter. The metal plate (fig. A/2) is welded on
two points of the filter (fig. A/3). Remove one welding point
with a file. Press metal plate out of filed point using a
screwdriver and move metal plate by hand up and down until
metal plate breaks out of filter. Fit filter so that welding points
are outside. Fit rubber boot so that the spring (fig. A/4) presses
the filter into the carburetor housing.
WARNING
On no account must only one restrictive device be removed. A
metal plate once removed from the filter must not be refitted
again. When mounting a filter with metal plate note that the
open end of the spring (fig. A/4) is between the four elevations
(fig. A/5) so that the bore of the metal plate remains free .
-18 -