How To Use; Before You Begin Cleaning - Vax VCWRU User Manual

Before you begin cleaning

Do not saturate your carpet.
• Vacuum your carpets thoroughly.
• Test for colourfastness – Wet a white absorbent cloth with the solution. In a small, hidden area of your carpet, gently rub the
surface with the dampened cloth. Wait ten minutes and check for colour removal or bleed with white paper towel or cloth. If your
carpet has more than one colour, check all colours.
• When cleaning an entire room, move furniture out of the area to be cleaned. If the furniture is too heavy to move, place aluminium
foil or wax paper under legs. This will prevent wood fi nishes from staining your carpet. Pin up furniture skirts and curtains.
IMPORTANT: Only use Vax carpet cleaning solution. Using other solutions may cause excess foaming. Excessive foam will prevent
the machine from working eff ectively. Using other solutions will invalidate the warranty.
Operating your pre-treatment wand
Pre-treating your carpet before washing will help to remove stubborn stains. Do not saturate your carpet.
Pour required dose of
pre-treatment solution
(approx.40ml per 1.0L of water).
Fill clean water tank with
solution mix.
vax.com.au
Mix solution with warm
water. (max 40°C).
Tighten cap before
returning tank to unit.
Remove pre-treatment
wand from holder.
Remove clean water tank.
Unwrap power cord and plug unit in.
Attach pre-treatment tube by
alligning inserts and pushing
in. Turn clockwise to secure.

How To Use

Spray evenly onto desired areas
and leave for 10-15 minutes
before washing carpets.
6