Mounting; Standard Mounting - Leuze lumiflex Scan Connecting And Operating Instructions

4

Mounting

4.1

Standard Mounting

SCAN units are mounted by means of through holes in the profile end pieces. (For the
distance between holes, see the dimensional table on page 17 and the dimensional
drawing on page 18.) The holes have a diameter of 5.3 mm.
This fixed mounting method is appropriate only when no adjustment is required (i.e. the
mounting surfaces are located in one plane and the mounting positions are at the same
height).
SCAN
SCAN
a = Mounting surface
b = Screw M5
c = Washer
d = Nut M5
Fig. 5: SCAN Standard Mounting
using Through Holes in
the End Pieces
11