Table of Contents
Advertisement
Follow this procedure to mount the antenna:
1.
Select an appropriate mounting position for your type of vehicle that has an
unobstructed area of 3 inches by 3 inches around the antenna.
2.
Attach the rubber cover/tail to the antenna, as shown in Figure 11, and press the
antenna cable into the rubber cover/tail. The rubber cover/tail will help to position
the antenna the correct distance from the edge of the roof or trunk lid.
3.
Clean the surface area of the vehicle where you will be installing the antenna with
the alcohol prep pad.
4.
Peel the protective material from the adhesive strips (Figure 11) and press the
rubber cover/tail firmly into place on the vehicle (Figure 12).
Protective Material
5.
Double check that the location of the antenna and rubber cover/tail are correct,
and continue to press firmly down on rubber cover/tail for another 30 seconds.
At room temperature (68 degrees), maximum adhesion usually occurs within 72
hours. During this period, avoid car washes and other contact with the antenna
and rubber antenna cable cover/tail.
Strain Relief
Adhesive Strips
Rubber Cover/Tail
Antenna Cable
figure 11
figure 11
[
]
1
Installation
Advertisement
Table of Contents
