Troubleshooting - JVC RM-RXUV9RMD Instructions Manual

Troubleshooting

• If you are having a problem with your System, check this list for a possible solution before calling for service.
• If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as
your dealer, for service.
Symptom
No sound is heard.
Poor radio reception
The CD skips.
The CD does not play.
The MD cannot be inserted.
Recording cannot be made on MD.
Timer fails to start.
Unable to operate the Remote Control.
Operations are disabled.
Possible Cause
• Connections are incorrect, or loose.
• Headphones are connected.
• The antenna is disconnected.
• The AM Loop Antenna is too close to the
System.
• The FM Wire Antenna is not properly
extended and positioned.
The CD is dirty or scratched.
The CD is upside down.
An MD has already been inserted.
The accidental erasure prevention knob of the
MD is set to the open position.
Present time is not correct.
• The path between the Remote Control and
the sensor on the Unit is blocked.
• The batteries have lost their charge.
The built-in microprocessor has malfunc-
tioned due to external electrical interference.
Action
• Check all connections and make correc-
tions. (See pages 3- 5.)
• Disconnect the headphones.
• Reconnect the antenna securely.
• Change the position and direction of the
AM Loop Antenna.
• Extend FM Wire Antenna to the best
reception position.
Clean or replace the CD.
Put the CD in with the label side up.
0
Press the MD button to eject the inserted
MD and insert a new MD.
Set it to the close position.
Set the time correctly.
• Remove the obstruction.
• Replace the batteries.
Unplug the System then plug it back in.
29