To Load Cds; To Unload Cds; Changing The Mp3/Wma Playback Mode - JVC MX-KC50 Instructions Manual

About Disc Indicator:
Disc Rotation
indicator
The Disc indicator consists of the following three kinds of indica-
tors:
Disc Number indicator: Lights all the time.
Selected Disc indicator:Lights for the currently selected
Disc Rotation indicator:Runs when the selected CD is
One Touch Play
The power comes on, and operations are done automatically.
❏ By pressing the CD 6 button, the System will come on, and if
a CD is loaded for the disc number that was lastly selected, it
will start playing from the first track.
❏ By pressing the CD1-CD3 button, the System will come on, and
if a CD is already loaded for the selected disc number, it will
start play from the first track.

To Load CDs

1
Press the CD Open/Close
Unit to open the tray.
2
Place one or two CDs, with its label side up,
onto the tray.
Be sure that the CD is securely seated inside the recess on the
disc tray.
With the label side up
3
Press the DISC SKIP button on the Unit and
place the next CD.
When you press the button, the tray turns for the next CD.
4
Press the CD Open/Close
Unit.
The tray is closed.
Disc Number
indicator
Selected Disc
indicator
disc number.
playing or paused. This indicator
goes out if a CD is not loaded for
the selected disc number.
0
button on the
0
button on the
❏ When you use an 8 cm (3'') CD, place it on the inner circle of the
tray.
❏ You can load CDs while listening to the other source or while
listening to the CD being played back.
❏ When power is turned off with the tray opened, the tray is auto-
matically closed.
❏ If the CD cannot be read correctly (because it is scratched, for
example), " NO DISC" appears on the display.

To Unload CDs

Take out the CD as shown below.
1
While the CD Player is stopped, press the CD
0
Open/Close button on the Unit to open the
tray.
2
Remove the CD, then press the DISC SKIP
button on the Unit.
The tray turns for the next CD.
3
Repeat step 2 to remove all the CDs.
4
Press the CD Open/Close
Unit to close the tray.
❏ You can remove CDs while listening to the other source.
Tips:
• Removing/changing the CDs during playback
While playing back a CD (e.g. CD1), you can remove or change
the other CDs (e.g. CD2 and CD3) by pressing the CD Open/Close
0 button. After removing or changing, press the same button to
close the tray.
Changing the MP3/WMA Playback
Mode
When playing an MP3/WMA disc, you can choose the playback
mode of the MP3/WMA disc as follows:
TRACK mode:
The unit recognizes only tracks (files). You can play an MP3/
WMA disc like an Audio CD.
GROUP mode:
The unit recognizes tracks (files) and albums (folders) on an MP3/
WMA disc. You can play an MP3/WMA disc according to the way
how they are grouped.
On the Remote Control ONLY
Press MP3/WMA MODE before or during playing
an MP3/WMA disc.
GROUP indicator appears when the MP3/WMA
playback mode is the GROUP mode.
• Each time you press the button, the MP3/WMA playback mode
changes between "GROUP" and "TRACK" alternately.
Using the CD Player
0
button on the
12