Setup The Wireless Lan Connection - Panasonic Viera TH-P42GT20D Operating Instructions Manual

Setup the wireless LAN connection

Setup the wireless LAN connection to enable the network service functions.
●
To setup the wireless LAN connection, the wireless LAN Adaptor is required. Confirm the
encryption key, settings and positions of your access point before starting setup. For details, read
the manual of the access point.
●
Please note that this TV does not support wireless public access points.
Start wireless LAN connection setup?
Yes No
Please connect the wireless LAN adaptor to a USB terminal.
You can setup the
wireless LAN connection later
"Network Setup" (p. 51)
●
To skip this step
EXIT
or select "No"
Connection Type
Please select network connection type.
WPS (Push button)
Search for access point
WPS (Push button)
WPS(Push button)
1) Please press the 'WPS' button on the access
point until its light flashes.
2) When the light is flashing select 'Connect' on
TV.
If you are unsure, please check the instruction
manual of the access point.
Connect
Search for access point
Available Access Points
No. SSID Wireless type Encrypt Reception
1 Access Point A 11n (2.4GHz)
2 Access Point B 11n (5GHz)
3 Access Point C 11n (5GHz)
Encryption Key Setting
Connection will be made with the following settings:-
SSID : Access Point A
Authentication type : WPA-PSK
Encryption type : TKIP
Please input the encryption key.
Encryption key
Access Point Settings
Encryption key
A B C D E F G H I J K L M N O P Q R S T
U V W X Y Z 0 1 2 3 4 5 6 7 8 9
a b c d e f g h i j k l m n o p q
u v w x y z ( ) + - . * _
Access Point Settings
Encryption key is set to:-
XXXXXXXX
Select 'Yes' to confirm.
Select 'No' to change.
Yes No
Wireless LAN connection setup is completed
●
If the connection is failed, check the encryption key, settings or positions of your access point.
For details, read the manual of the access point.
●
If connection to the access point is successful, we recommend you perform the "Connection Test"
to confirm connection to the internet has been made. The "Connection Test" can be found in the
Network Setup menu (p. 53).
Connect the Wireless LAN Adaptor to the USB 1 or 2 port
Internet
environment
Access point
select "Yes"
access
Select the connection type
confirm
select
Press the WPS button on the access point until the light flashes.
And then, press the OK button to connect the Wireless LAN Adaptor
and the access point.
●
Ensure that your access point supports WPS for this method.
●
WPS: Wi-Fi Protected Setup
Access points found automatically are listed.
Select your desired access point.
access
select
Access the encryption key
input mode
●
If the selected access point is not encrypted, the confirmation screen
will be displayed. It is recommended to select the encrypted access
point.
Enter the encryption key of the access point.
Set characters one by one
! : #
select
r s t
set
●
You can set characters by using numeric buttons.
Select "Yes"
select
set
●
To re-enter the encryption key, select "No".
Wireless LAN Adaptor
●
If your access point supports WPS
(Push button), then select this option.
If not, select "Search for access point".
TM
●
To search access points again
Y
●
For the information of the
highlighted access point
Store
RETURN
RECALL
13