Advertisement
Model DFG-RSA Configurable Load Cell Adapter
4.3 Force / Torque Capacities & Resolutions
1
2
Use the Force Capacities & Resolutions and Torque Capacities & Resolutions screens to program
the capacity appropriate for the sensor. The number of available units of measurement and displayed
resolution depend on the indicator being used. Refer to Section 5 for detailed information.
Refer to the following procedure:
1. Select the appropriate capacity. Use the
capacities. The Capacity table shows the available units of measurement and their corresponding
capacities. The Resolution table displays the increment size for each of the available units.
Select the Model DFG-RS5 or Model DFG-RS3 radio button in the lower right corner of the
screen to display the units and resolutions available for each indicator.
2. The software may be used to configure a bi-directional sensor, such as an S-beam, or single
direction sensor, such as a load button. Select the appropriate direction.
3. Optionally enter an identification number for the sensor. This number will be displayed in the
indicator's power-up sequence and Information screen.
Note: The identification number may not begin with the letter sequence "MR".
4. Click Program Adapter. A progress bar is supplied below this button, for visual convenience.
Do not disconnect the communication cable until this process is complete, denoted by the PASS
or FAIL indicator.
3
4
and
arrows to scroll through additional
User's Guide
7
Advertisement
