What To Do If - Bosch WAE24162GR/ Series Instruction Manual

What to do if ...

Water is leaking out. – Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply. – Start/Pause
Detergent not dispensed. – Tap not turned on?
– Filter blocked? Clean the filter –> page 10.
– Supply hose kinked or trapped?
Washing machine door – Safety function active. Wait approx. 2 minutes.
cannot be opened.
– Is X
4.
Programme does not – Start/Pause
start.
– Washing machine door closed?
Detergent solution is not – Is X
drained. 4.
– Clean the detergent solution pump –> page 10.
– Clean the waste pipe and/or drainage hose.
Water not visible in the – Not a fault - water below the visible area.
drum.
Spin result not – Distribute large and small items of laundry evenly in the drum.
satisfactory.
–
– Too low a speed selected? –> page 5.
Spin cycle performed – Not a fault - unbalanced load detection system adjusts the
several times. imbalance.
Residual water in the – Not a fault - the action of the care product is not affected.
compartment for care
– Clean the insert if necessary –> page 9.
products.
Odour formation in the – Run programme
washing machine. laundry. Use standard detergent.
Foam escaping from the – Too much detergent used?
detergent drawer. If foam is escaping from the detergent drawer:
Mix 1 tablespoon of fabric softener with ½ litre of water and pour
into compartment II (not with outdoor or down fabrics).
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation, – Are the appliance feet fixed?
vibrations and "walking" Secure the appliance feet –> Installation instructions.
during the spin cycle.
– Transportation safety devices removed?
Remove the transportation safety devices –> Installation
instructions.
The indicator lights do – Power cut?
not function during
– Fuses tripped? Reset/change the fuse.
operation.
– If the fault occurs repeatedly, call the after-sales service.
Programme sequence – Not a fault - unbalanced load detection system adjusts
longer than usual. imbalance by repeatedly distributing the laundry.
– Not a fault - foam detection system active - adds an additional
rinse cycle.
Detergent residues on – Occasionally, phosphate-free detergents contain water-insoluble
the laundry. residues.
– Select
after washing.
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to Off and remove the mains plug from the socket.
– Turn off the water supply and call the after-sales service –> Installation instructions.
not selected?
(Rinse Hold, without final spin) selected? –> page 3,
selected?
(Rinse Hold, without final spin) selected? –> page 3,
(Easy-Iron) selected? –> page 5.
/ (Cottons) 90 °C without
/ (Rinse /Spin) or brush out the laundry
Observe the safety instructions on page 8.
Read these instructions and the separate installation instructions before
operating the washing machine.
11
Washing machine
Instruction manual en