JVC DLA FS-X3 Instructions Manual page 60

On the Remote Control
1
Press the CLOCK/TIMER button repeat-
edly until "ON (time)" appears on the
display.
At this time, "DAILY" indicator blinks on the display.
Each time you press the button, the display changes as
follows.
DAILY ON?/DAILY OFF? = ON (time)* = Clock
setting display = Cancelled = (back to the beginning)
*: Select this item!
The System enters ON-time setting mode, and the cur-
rent ON time appears on the display and the hour digits
blink.
2
Setting the ON time (Example: 10:15).
1. Press the 3 or 2 button to set the hour you want the
System to come on, then press the SET button.
The minute digits of the ON time blink on the display.
Pressing the 3 button moves the time forwards and
pressing the 2 button moves it backwards.
Holding down the button moves the time.
2. Press the 3 or 2 button to set the minute, then press
the SET button.
The System enters OFF-time setting mode, and the
hour digits blink.
3
Setting the OFF time (Example: 13:30).
Note that the same time as the ON time cannot be set.
1. Press the 3 or 2 button to set the hour you want the
System to be turned off, then press the SET button.
The minute digits of the OFF time blink on the dis-
play.
2. Press the 3 or 2 button to set the minute, then press
the SET button.
The System enter the Music Source Selecting mode
and "FM?" appears on the display.
4
Selecting the music source.
Press the 3 or 2 button to select the music source you
want to listen to, then press the SET button.
Each time you press the 3 or 2 button, the display
changes as shown below:
Ô Ô
FM? AM? CD?
Ô
(back to the beginning)
*: If the name has been changed, that name (e.g.
"TAPE") will appear. (See page 20.)
According to the music source you have selected, the
next operation differs.
FM? : Tunes in to the specified preset FM sta-
tion.
AM? : Tunes in to the specified preset AM sta-
tion.
CD? : Plays the specified track on the speci-
fied CD.
LINE? : Plays an external source.
MELODY? : Select one of 10 melodies.
Preparation for each music source:
Perform the following operation according to the music
source you have selected. Then, the System enters Vol-
ume Setting mode.
G When selecting "FM?" or "AM?"
Press the 3 or 2 button to select the preset station
number, then press the SET button.
• If you select the display "- -", the current broad-
cast station is selected.
G When selecting "CD?"
Press the 3 or 2 button to select the track number
you want to start playback, then press the SET button.
• If you select the display "- -", playback will start
from the first track.
G When selecting "LINE?"
Prepare the external equipment so that it will turn on
at the ON time set by the System.
To allow this, the equipment should have the timer
function.
G When selecting "MELODY?"
Press the 3 or 2 button to select one of melodies
(MELODY 1-10). Then, the selected melody is
played back.
Using the Timers
Ô Ô
LINE?* MELODY?
24