Rear Panel - Pioneer VSX-D710S Service Manual

VSX-D710S
6 2 /DTS button
Use to put receiver in DOLBY DIGITAL, DOLBY SUR-
ROUND and DTS modes.
DSP button
Use to put receiver in one of the DSP modes.
TEST TONE button
Use to sound the TEST TONE when setting up the
surround sound of the receiver (the 2 /DTS mode must
be on).
SIGNAL SELECT
Use to select the proper signal (analog, digital) for the
source your are inputting.
7 CH SELECT button
Use to select a speaker when setting up the surround
sound of the receiver. To use first press the
then operate this button.
CH LEVEL +/–
Use to set up the levels of the surround sound of the
receiver. To use first press the
this button.
FUNCTION button
Use to select the playback or recording source. This
button lets you cycle through the different functions of the
receiver in the following order: CD, TUNER, AUX, CDR/
TAPE, VCR/DVR, DVD/LD, VIDEO, and TV/SAT.
8 LOUDNESS button
Use to switch on the loudness. This feature is useful for
getting good bass and treble sounds listening at low
volumes.
FL DIMMER button
Use this button to make the fluorescent display (FL)
dimmer or brighter. There are three brightness settings
as well as an off setting.
SETUP button
Use this button when setting up the remote control to
control other components.
MUTING button
Use to mute the sound or restore the sound if it has been
muted.

Rear Panel

IN
AM LOOP
AUX
ANTENNA
IN CD
O
U
T
VCR /
DVR
IN IN
TV /
IN
IN
SAT
DVD
/ LD
IN IN
FRONT
FM R
R
OUT
E
UNBAL
C
75Ω
CD - R
FM / TAPE
P
/ MD
ANTENNA
L
IN
A
Y
SUB
WOOFER
R L
62
button
RCV
button then operate
RCV
DIGITAL IN
2
PCM / / DTS
CONTROL
COAX OPT1 OPT2 OPT
OUT
TO
MONTOR
TV
S
OUT
FRONT
OUT
SPEAKERS
R
S
TO
MONTOR
OUT
TV
VCR /
DVR
S
SUB
WOOFER
IN
PREOUT
S
TV /
L
SAT
IN
SURROUND
CENTER
S
DVD 5.1 CH
IN
INPUT DVD
/ LD
9 THE FOLLOWING BUTTONS ARE DEDICATED TV
CONTROL. THEY ARE ONLY USED FOR CONTROL-
LING YOUR TV.
TV FUNC button
Use select the TV function.
TV button
Use to turn on/off the power of the TV.
TV VOLUME +/– buttons
Use to adjust the volume on your TV.
0 MENU button
Use to access different menus associated with your DVD
player.
- MASTER VOLUME +/– buttons
Use to set the overall listening volume.
= CHANNEL +/– buttons
Use to select the stations of memorized radio frequen-
cies. Also use to skip tracks backward or forward on CDs,
DVDs, etc.
~ @ # % fi ( TUNE/ST +/–) & ENTER buttons
Use these arrow buttons when setting up your surround
sound system . These buttons are also used to control
DVD menus/options and for deck 1 of a double cassette
deck player. The TUNE/ST +/– buttons can be used to
find radio frequencies and preset stations, respectively.
! DISC (ENTER) button
Use to select a disc an in multi-CD player. To use first
press the button then operate this button.
RCV
@ RECEIVER
(POWER) button
This switches between STANDBY mode and power ON
for this receiver.
# LED DISPLAY
This display flashes when a command is sent from the
remote control to the receiver. It also flashes at other
times, for example when teaching the receiver preset
codes, with specific meanings.
DIGITAL
OUT
COMPONENT
VIDEO
MONITOR OUT
Y P P
B R
SURROUND
CENTER
A
SPEAKERS
SPEAKERS
L R
CENTER
PREOUT
(DVD/LD) IN 1
P
R
Y P
B
Y P
B
2 P
(TV/SAT) IN
R
FRONT
B
SPEAKERS
L R L