Honda Civic Si 2005 Owner's Manual page 163

Changing a Flat Tire
JACKING POINT
7. Place the jack under the jacking
point. Turn the end bracket
clockwise until the top of the jack
contacts the jacking point. Make
sure the jacking point tab is
resting in the jack notch.
168
WHEEL
WRENCH
EXTENSION
8. Use the extension and the wheel
nut wrench as shown to raise the
vehicle until the flat tire is off the
ground.
9. Remove the wheel nuts, then
remove the flat tire. Place the flat
tire on the ground with the outside
surface facing up.
BRAKE HUB
10. Before mounting the spare tire,
wipe any dirt off the mounting
surface of the wheel and hub with
a clean cloth. Wipe the hub
carefully; it may be hot from
driving.
11. Put on the spare tire. Put the
wheel nuts back on finger-tight,
then tighten them in a crisscross
pattern with the wheel nut wrench
until the wheel is firmly against
the hub. Do not try to tighten
them fully.