2.1
Chassis cover
2.1.1
Removing the rear cover
1.
Loosen the two thumbscrews on the rear panel to release the rear cover from the
chassis.There's no need to remove the thunbscrews, just loose them.
2.
Firmly hold the rear cover and slide it towards the back panel for about half an inch to
the front cover.
3.
Remove the rear cover
from the chassis.
The chassis is covered
with a layer of film.
Before starting up the
system, remove the film
to avoid overheating.
2-2
4
3
2
1
screws
Front cover side thumbscrew
Chapter 2: Hardware setup