Advertisement
Rear Panel
1. POWER CONNECTOR
The connector is used to connect the AC
power source to active loudspeaker.
2. POWER SWITCH
Press the button for turning on/off.
3. POWER
This LED indicates if loudspeaker is
turned on.
4. BASS
This control allows adjusting low tone of
sound. Adjusting level ± 14dB
5. TREBLE
This control allows adjusting high tone of
sound. Adjusting level ± 14dB
6. VOLUME
Master volume control for adjust the
sound level.
7. RCA INPUT
Stereo RCA connector for line level audio.
If mono mode is using, only the left input is
active.
8. TRS jack input
Stereo 3,5 mm TRC jack connector for line
level audio. If mono mode is using, only the
"tip" pin of the stereo jack is active.
9. STEREO/MONO SWITCH
Set this switch to stereo if you have stereo
audio and set mono if you have mono. When
mono mode is selected the left input are
active only.
10. SPEAKER OUTPUT
This output is designed to connect the
passive Power Box 5 loudspeaker. The
minimum load impedance - 4Ω. Please pay
attention to polarity during the wiring.
11. FUSE HOLDER
Use T1AL 250V fuse only. Contact with
qualified service personnel if fuse blows up
constantly.
Advertisement
