Epson EB-G6750WU Installation Manual page 17

Reading the Indicators
Refer to the following table to see what the indicators mean and how to remedy problems that they indicate.
If all indicators are off, check that the power cord is connected correctly and that the power is being supplied normally.
Sometimes, when the power cord is unplugged, the [
Status Cause
Internal Error
Fan Error
Sensor Error
High Temp Error
(Overheating)
Lamp Error
Lamp Failure
] indicator remains lit for a short period, but this is not a fault.
t
Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
s "Epson Projector Contact List" p.81
Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
s "Epson Projector Contact List" p.81
The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the projector switches to standby
mode, so check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, remove the power plug from the electrical outlet, and clean or replace it.
If the error continues after checking the points above, stop using the projector, remove the power plug from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
s "Epson Projector Contact List" p.81
When using at an altitude of 1500 m or more, set High Altitude Mode to On.
Press [Menu] button > Extended > Operation > High Altitude Mode
Check the following two points after turning off the projector and removing the power plug from the electrical outlet.
• Take out the lamp and check if it is cracked.
• Clean the air filter.
If the lamp is not cracked: Reinstall the lamp and connect the plug to an electrical outlet.
If the error continues: Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest
address provided in the Epson Projector Contact List.
s "Epson Projector Contact List" p.81
: Lit : Flashing : Off : Varies according to the projector status
Remedy or Status
17