Purenex RO-50 Installation & Maintenance Manual

Purenex RO-50 Installation & Maintenance Manual

Domestic reverse osmosis unit
Hide thumbs Also See for RO-50:

Advertisement

DOMESTIC
DOMESTIC
DOMESTIC
DOMESTIC REVERSE
INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION AND
Ⅰ. YOUR RO SYSTEM AND ITS PARTS
Ⅱ. INTRODUCTION
Ⅲ. WATER PRODUCE TECHNOLOGICAL PROCESS
Ⅳ. NAME OF EACH COMPONENT
Ⅴ. ELECTRIC PRINCIPLE SKETCH MAP
Ⅵ. TECHNICAL SPECIFICATION
Ⅶ. INSTALLTION INSTRUCTIONS
Ⅷ. FUNCTION OF IC CONTROLLER
Ⅸ. STARTING UP YOUR RO SYSTEM
Ⅹ. MAINTATENANCE
Ⅺ. NOTICE ITEM
Ⅻ. TROUBLE SHOOTING GUIDE
ⅫⅠ. NSF STARDARD LISTING
REVERSE
REVERSE
REVERSE OSMOSIS
AND
AND
MAINTENANCE
MAINTENANCE
AND MAINTENANCE
MAINTENANCE MANUAL
RO-50/75/100G
CONTENT
CONTENT
CONTENT
CONTENT
OSMOSIS
OSMOSIS
OSMOSIS UNIT
MANUAL
MANUAL
MANUAL
UNIT
UNIT
UNIT

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RO-50 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Purenex RO-50

  • Page 1 MAINTENANCE MAINTENANCE MANUAL MANUAL INSTALLATION INSTALLATION AND AND MAINTENANCE MAINTENANCE MANUAL MANUAL RO-50/75/100G CONTENT CONTENT CONTENT CONTENT Ⅰ. YOUR RO SYSTEM AND ITS PARTS Ⅱ. INTRODUCTION Ⅲ. WATER PRODUCE TECHNOLOGICAL PROCESS Ⅳ. NAME OF EACH COMPONENT Ⅴ. ELECTRIC PRINCIPLE SKETCH MAP Ⅵ.
  • Page 2 ead through all the instructions before installing and using this RO system. We are certain that you will be satisfied with its performance and that it will server your need for safe and clean drinking water. If you have any trouble, please contact with your local dealer. Ⅰ.
  • Page 3 Ⅲ..WATER WATER PRODUCE TECHNOLOGICAL PROCESS WATER WATER PRODUCE PRODUCE PRODUCE TECHNOLOGICAL TECHNOLOGICAL TECHNOLOGICAL PROCESS PROCESS PROCESS Raw water PP Spun Fiber Granular Carbon Filter Block Carbon Filter High Pressure Pump Pure water RO membrane In-line Carbon Filter Faucet Pressure Tank Drain Water...
  • Page 4: Technical Specification

    B02, , , , B B B B 03, 03, B B B B 04 04 04 04 Series Series Series RO-50/75/100G-C01,C02 RO-50/75/100G-C01,C02 RO-50/75/100G-C01,C02, , , , C C C C 03, 03, C C C C 04 04 04 04 Series Series Series This for RO-50/75/100G-B01,...
  • Page 5 Ⅶ..INSTALLTION INSTALLTION INSTALLTION INSTRUCTIONS INSTRUCTIONS INSTALLTION INSTRUCTIONS INSTRUCTIONS 1. Confirm 1.1..Check your tools. 1.2..Check accessories...
  • Page 6: Diagram Of Connection

    2. Diagram of Connection 3. Site Selection for major system components The R.O. System was designed to fit under a sink, however, because of space limitations or other reasons, the system’s flexible design allows for other locations. When determining the location remember that access to a cold water tap line, the household drain, and ease of filter replacement are important consideration.
  • Page 7: Installation

    3.4. 3.4. 3.4. 3.4. Feed Feed Feed Feed Water Water Water Water Connection Connection Connection Connection – – – – The Feed water Valve should be located as close to the R.O. Unit as possible. USE A POTABLE COLD WATER SUPPLY ONLY. Softened water is preferred as it will extend the life of the R.O.
  • Page 8 4.3. 4.3. Drain Drain Clamp Clamp Installation Installation 4.3. 4.3. Drain Drain Clamp Clamp Installation Installation The following are instructions for discharging into the sink drainpipe. 4.3.1. 4.3.1. 4.3.1. Position the Drain clamp on the drainpipe above the drain trap. Allow room for drilling. Tighten securely. 4.3.1.
  • Page 9 03, B B B B 04 04 04 04 Series Series Series This for RO-50/75/100G-B01, RO-50/75/100G-B01, B02 Series 1. Power lamp is bright when starting machine, after 5 seconds, machine works and automatically flush for 1 minute and 30 seconds, the indicating lamp (POWER, PUMP, FLUSH) is bright.
  • Page 10 LCD IC IC Controller Controller This This This This is is is is for for RO-50/75/100G-C01, RO-50/75/100G-C01, RO-50/75/100G-C01, RO-50/75/100G-C01, C02 C02, , , , C C C C 03, 03, C C C C 04 04 04 04 Series Series...
  • Page 11 Ⅹ..MAINTATENANCE MAINTATENANCE MAINTATENANCE MAINTATENANCE To ensure the system operate at its optimum level, certain routine maintenance must be performed. Frequency of maintenance performance will depend on feed water quality and level of system usage. * Change PP spun fiber filter as required or every 3 to 6 months depending on raw water quality and consumption.
  • Page 12: Trouble Shooting

    NOTE: NOTE: NOTE: NOTE: Filters and membrane are consumables. Their replacement time is depending on the quality of raw water and water consumption. If perform the safe frequency of changing, which can guarantee the normal running of RO system and water quality of the output pure water, so, the above suggestion of filter cartridge changing is only for reference.
  • Page 13: Water Treatment

    ⅫⅠ..NSF STARDARD LISTING NSF STARDARD STARDARD STARDARD LISTING LISTING LISTING DRINKLING DRINKLING DRINKLING DRINKLING WATER WATER WATER WATER CONTAMINANTS CONTAMINANTS CONTAMINANTS CONTAMINANTS AND AND THEIR THEIR THEIR THEIR CONTROL CONTROL CONTROL CONTROL WITH reverse osmosis water treatment system WITH...

This manual is also suitable for:

Ro-100gRo-75Ro-50gRo-75g

Table of Contents