Advertisement
Star Phantom
Star Phantom
®
Rear Window Undercover Interior LED Lightbar
Models
ULB42-1 ULB42V-1 ULB44-1
(Discrete)
(Discrete Value)
(Gen 4 Starburst)
IMPORTANT:
Please read all of the following instructions before installing your new warning light.
Please Note: These instructions are provided as a general guideline only. Specific
Mounting and/or wiring, may be necessary and are the sole responsibility of the
installer. Star Headlight & Lantern Co., Inc. assumes no responsibility for the
integrity of the installation for this or any of its products.
PLITSTR317 REV. F
5/20/14
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Star Phantom ULB42-1
Summary of Contents for Star Phantom ULB42-1
- Page 1 Star Phantom Star Phantom ® Rear Window Undercover Interior LED Lightbar Models ULB42-1 ULB42V-1 ULB44-1 (Discrete) (Discrete Value) (Gen 4 Starburst) IMPORTANT: Please read all of the following instructions before installing your new warning light. Please Note: These instructions are provided as a general guideline only. Specific mounting and/or wiring, may be necessary and are the sole responsibility of the installer.
- Page 2 IMPORTANT: Please read all of the following instructions before installing your new warning light. ® Star Phantom line of lights is designed to be mounted on the inside of your vehicle. They are not intended for exterior applications and are not warranted against water damage.
- Page 3 Mounting (CONT'D) This light is designed to be mounted in the rear window of a vehicle using both the forked brackets and the corner post brackets. Failure to use both brackets could result in a faulty mount and will void the warranty. If your vehicle is not compatible with these brackets you must custom design mounting brackets Forked Brackets Corner Post Brackets...
- Page 4 1. Connect one of the double-slotted "L" brackets to each of the slotted straight brackets using one of the screws, a flat washer, a tooth washer, and a nut. Star Phantom Connect one bracket to each end of your using the ®...
- Page 5 Corner Post Bracket Installation (CONT'D) 3. Adjust the mounting brackets so that they rest flat against the corner post on each side of the vehicle., then tighten all the screws. 4. Mark the two spots where you will be attaching your screws to the corner post and drill a 1/8"...
-
Page 6: Operating Instructions
Operating Instructions Star Phantom The ULB42-1 rear window ® is designed for simple operation. This unit has only a Pattern Select Button. This is a momentary switch. Each time this switch-button is depressed while The Star Phantom ®... - Page 7 Toggle Mode: Pressing and holding the pattern select button until the LED’s flash three • times (approx. 9 seconds) will toggle the “steady output” for patterns 31 and 32. ® Star Phantom will remember the pattern it was in when turned off and display the • same pattern when re-activated.
- Page 8 These lights use state-of-the-art Light Emitting Diode (LED) technology. These warning lights are comprised of ultra-high intensity LEDs that are controlled by a solid state flasher unit to efficiently produce light output with lifetimes up to 100,000 hours. Under normal circumstances, you will not need to replace any LEDs in this light.
Need help?
Do you have a question about the ULB42-1 and is the answer not in the manual?
Questions and answers