Advertisement
CAUTION
Dangerous! Don't put your fingers into or on the laminator while in operation.
Injury or burns may occur.
Please make sure to use the correct voltage and not to overload
the power supply.
Ensure the machine is unplugged before moving to another
location, or when not in use.
Do not insert any other material except for the laminating pouches
into the laminator as these objects may cause malfunctions or
damage the laminator.
BRIEF PROBLEM SHOOTING
Problem
Lamination jammed
combined with noise and
a burning smell coming
from the machine
While laminating the
machine stops working.
Indicated by the lights
going off.
4
Cause
1. Machine temperature
to high.
2. Excess lamination
adhering to the roller.
3. Lamination pouch
exceeds the standard
thickness.
1. External power
have been switched
off.
2. The machine over
heated and the
heat protection device
cuts the power.
Solution
Turn off the power
and pull the lamination
out of the machine using
the Jam Release Switch
(LF9052 &LF9051) or
Jam Reverse (LF9055).
If the problem persists
send the machine for
a service at a registered
service centre.
Check main power
supply, if on, switch the
machine off and wait 30
min before proceeding.
If the problem persists
send the machine
for a service at a
registered service centre.
Advertisement
