Advertisement
OPERATION GUIDE
1
2
3
4
Cold Lamination
- For self adhesive film
Turn the selection switch to "cold", the green light will indicate that the
machine is ready for use. Wait 40 minutes after using the hot lamination
option before using the cold lamination option. The machine needs time
to cool down.
2
Switch the power "ON" to start. Wait 4 - 8
minutes for the machine to heat up. Green
light will indicate that the machine is
ready to use.
Adjust the temperature according to
!
the laminating pouche thickness.
Select the laminating pouch according to
the size of paper/photo you want to laminate.
Place the paper/photo into the laminating
pouch. Trim/cut excess film off the sides
where necessary.
Insert laminating pouch in the front
of machine
The laminator will feed the laminating
pouch through the heat rollers to the back
of the machine. If the surface of the
laminating pouch is opaque, it means the
film did not melt completely, due to the
machine not being warm enough. Just laminate
the pouch again.
Advertisement
