Speaker Connections - GME GR9220W Instruction Manual

Gr9200 series marine stereo systems
Table of Contents

Advertisement

speaker connections

When connecting the speakers, observe the correct polarity as
shown in the diagram above right. Incorrect polarity will result in a
reduction of Bass response and stereo effect . the use of speakers
with an impedance of less that 4 Ohms is not recommended, as
they will cause excessive loading of the GR9200's output circuit
and may result in the radio overheating.
caution: The GR9200 is a four-speaker system that
requires 2 separate wires for each speaker .
A range of GME speakers is available from your local
GmE retailer .
Connect all four speakers as shown in the diagram above.
Adjust the Fader control for the required front/rear balance.
If you wish to connect only two speakers, connect these to
the rear speaker wires . the remaining speaker wires should
be insulated to ensure they cannot short circuit together or
to the vessel's 12 Volt or negative electrical Bus. If using only
two speakers, adjust the Fader control to the rear speakers.
G r 9 2 0 0 s E r i E s
antenna connections
connect an Am/Fm marine antenna to the antenna socket
extending from the rear of the Gr9200 . For information on
a suitable antenna, contact your nearest GME branch or
marine retailer .
Wired remote control
The GR9200 has 2 additional fly leads at the rear enabling
up to 2 GME wired remotes (RCU9200) to be connected.
One or more additional 5 meter leads (LEO24) can also be
inserted if required up to a maximum of 15 meters .
ipod® connectivity
The GR9200 has a 3rd fly lead which, when connected with
an LEO23 (optional 1.1 meter lead), enables an iPod® to
be connected directly to the stereo. Limited functions of the
iPod® can be accessed via the GR9200, including the
selection of albums and songs. Access to displaying the
iPod® library on the GR9200 is not available however the
iPod library and all functions can be viewed on the iPod.
reset Button
When the installation is complete, remove the front panel
and press the Reset button using a paper clip or similar
i n s t r u c t i o n m A n u A l
PA G E 9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gr9220bGr9240bGr9240w

Table of Contents