Sears 39.18205SR - 1/2 HP Owner's Manual page 14

LOCATE WALL PUSH BUTTON (OR ANY ADDITIONAL PUSH BUTTONS) WHERE THE GARAGE DOOR IS
VISIBLE, AWAY FROM DOOR AND DOOR HARDWARE AND OUT OF THE REACH OF CHILDREN.
SERIOUS PERSONAL INJURY FROM A MOVING GARAGE DOOR MAY RESULT FROM MISUSE OF OPENER.
DO NOT ALLOW CHILDREN TO OPERATE WALL PUSH BUTTON(S) OR REMOTE CONTROL TRANSMITTER.
FASTEN THE CAUTION LABEL ON THE WALL NEAR WALL PUSH BUTTON AS A REMINDER OF SAFE OPERATING
PROCEDURES.
INSTALLATION STEP 5
Install Wall Push Button
Remove about 1/4" of insulation from each end of 2-
strand bell wire. Connect one end to the screw
terminals on back of Wall Push Button (or doorbell-
type push button) as shown. NO POLARITY IS
REQUIRED.
Fasten the Wall Push Button with 6ABx1" sheet
metal screws. The doorbell-type push button has
6ABx1-1/2" sheet metal screws. Use anchors if
attaching to dry wall. Install on an inside garage wall.
A convenient place is alongside the service door and
OUT OF THE REACH OF CHILDREN.
Run bell wire up the wall and across the ceiling to the
opener. Secure with insulated staples.
Receiver terminals and antenna are located on back
panel of opener. Position antenna wire as shown.
Then connect the wire by color to the white and red
opener terminal screws.
Lighted
Pushbutton
OPERATION OF THE WALL PUSH BUTTON
Press to open or close door.
Press again to REVERSE door during the CLOSING
cycle or to STOP door during OPENING cycle.
DOOR BELL-TYPE
LIGHTED PUSH BUTTON
Terminal Screws
Staples
WIRING INSTRUCTIONS FOR ACCESSORIES
To red and white opener terminals
14
WALL PUSH BUTTON
Terminal Screws
2-Strand
Bell Wire
RED
Opener
Terminal
Screws
Rear Panel
of Opener
Outdoor Key Switch:
Top Installation
Flange
Bottom Installation
Flange
WHT BLK
H H
L L
I I
O O
G G
W W
H H
N L N L
O R M A O R M A
UP DOWN
FORCE FORCE
243532tv 2243436
1376335361817353
askjhdoc lkjhoi `hoic
zjh zjh cc aiu ickck c
xzckjckuc czkzxkkcc
kkjhzxkjhzckyc . jh c
zjhxckjc cliyvn ckjc
zlh lkchy l cagv
,vbcjdu dkcid sac ccxb
Antenna