Mechanical Setup, Standard Screen - Clarity WN-5220-S User Manual

Mechanical Setup, Standard Screen

Install the WN-5220-S in the desired position and connect the power
and signal cables. See the following section for an explanation of the
cabling configuration.
To setup the WN-5220-S display in a video wall configuration, follow
these steps:
1. Grasp the screen on each side
at the bottom
2. Slip fingers between the screen
frame
3. Using both hands...
Figure 1 Connecting display units
The "screen" you are removing is 2 or 3 inches thick.
Pull out at the bottom first, to separate the latch-
hooks from the latches. It comes out with a "pop."
The screen should now be loose at the bottom, but
still attached at the top.
Slip fingers between the screen frame and the
display chassis, as close to the top latches as
possible and pull the top of the screen from the
latches.
Carefully remove the screen and set it aside.
WN-5220-S VideoWall User's Guide
13