Slant/Fin Galaxy GXH-300H Installation And Operating Instructions Manual page 12

12
Operating Instructions
1. STOP! Read the safety information above on this page.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot by
hand.
5. Remove control access panel.
GAS VALVE 36C84
GAS
INLET
Gas Control Knob Shown in Off Position
6. Turn gas control knob clockwise
push in knob slightly then continue to "OFF.
NOTE: Knob cannot be turned to "OFF unless knob is
pushed in slightly. Do not force.
7. Wait five (5) minutes (longer for propane) to clear out any
gas, then smell for gas, including near the floor. If you then
smell gas, STOP! Follow "B" in the safety information above.
If you don't smell gas, go to next step.
8. Turn gas control knob counterclockwise
stops, release, then continue to "ON".
9. Replace control access panel.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the instructions To
Turn Off Gas To Appliance" and call your service technician
or gas supplier
To Turn Off Gas To Appliance
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to be
performed.
3. Remove control access panel.
4. Turn gas control knob clockwise
in knob slightly then continue to "OFF". Do not force.
5. Replace control access panel.
Knob
Gas
Inlet
Side View
Gas Valve
No. 36C84
Figure 12
until knob stops,
until knob
until knob stops, push
Pilot Sensor Switch
No. 3098-185
Capillary Tube
No. 5059
Pilot Lighter
Ignition Cable
Electronic Ignition
Pilot in boiler
Aluminum
Pilot Gas Tube
4. Intermittent Pilot System (IID).
FOR BOILERS EQUIPPED WITH HONEYWELL GAS VALVE
VR8204 or VR8304 (see figures 13 and 14).
SAFETY INFORMATION
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly,
a fire or explosion may result causing property damage, per-
sonal injury or loss of life.
A. This appliance is equipped with an ignition device which automati-
cally lights the pilot. Do not try to light the pilot by hand.
B. BEFORE OPERATING smell all around the appliance area for gas.
Be sure to smell next to the floor because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• DO NOT try to light any appliance.
• DO NOT touch any electric switch; DO NOT use any phone in
your building.
• Immediately call your gas supplier from a neighbor's phone. Fol-
low the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob. Never
use tools. If the knob will not push in or turn by hand, don't try to
repair it, call a qualified service technician. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under-water. Imme-
diately call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas control
which has been underwater.
Operating Instructions
1. STOP! Read the safety information above.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device which
automatically lights the pilot. DO NOT try to light the pilot by
hand.
5. Remove control access panel.
6. Turn gas control knob clockwise
continue to "OFF". DO NOT force.
7. Wait five (5) minutes (longer for propane) to clear out any
gas, then smell for gas, including near the floor. If you then
smell gas, STOP! Follow "B" in the safety information above
on this page. If you don't smell gas, go to next step.
8. Turn gas control knob counterclockwise
9. Replace control access panel.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the instructions "To
Turn Off Gas To Appliance" and call your service technician
or gas supplier
Figure 13. Valve VR8204 or VR8304
GALAXY
until knob stops then
to "ON".