Dk43 Dethatcher Kit Installation - Huskee MC43TSC Operator's Manual

dk4 dEThATChER kIT INSTAllATION (OPTIONAl ACCESSORY)
The Dethatcher Kit is very effective for lifting away the excessive matted layers of thatch that can prevent moisture,
oxygen and nutrients from penetrating the soil and can harbor disease and insects. Use in Spring, Summer, and Fall to
bring life and color back to your lawn.
1. Disconnect spark plug wire from spark plug. Remove the cultivating tines (if so equipped). Refer to exploded view
below for detailed assembly.
2. Slide the Left and Right Dethatcher Assemblies onto the tine shaft making sure the Right Assembly is installed on the
right side and Left Assembly is installed on the left side as defined from the user's position.
3. Secure dethatcher assemblies using the hairpins 46134.
4. Slide dethatcher shield over the unit's tine shield from the rear of the unit and secure using bolts 4694, washers 4692,
and nuts 4694.
5. Secure the lower part of the dethatcher shield to the drag stake mount using the detent pin 46145. Re-connect
spark plug wire.
6. Install wheel extension plate 4676 using additional bolts 46142 and nuts 4650
NOTE: The drag stake should not be used when using the dethatcher kit.
46134
Hairpin
4708
Right Side
Dethatcher
Assembly
(fits both models mC4TSC & mC4ETSC or stand-alone as md4)
Slide Shield Forward
800-45-6007
4691
Bolt
4692
Washer
4694
Nut
dk4 dethatcher kit
Plate Wheel Extension
GetEarthquake.com
OPERATOR INSTRUCTIONS ANd PARTS
MC43ETSC & MC43TSC Cultivator
46134
4651
Tine Shaft
4676
4707
Left Side
Dethatcher
Assembly
46145
Detent Pin
Nuts/Bolts (4 each)
4650/46142
Page 2