Factory Mode; How To Enter Into Factory Mode; Key Command; Contents Of Adjustment Mode - Panasonic TH-37LRT12U Service Manual

TH-32LRT12U-A * TH-37LRT12U/M/A

5 Factory Mode

5.1.

How to enter into Factory Mode

Press and hold [VOL+] button and [VOL-] button of the main unit more than 3 seconds.
5.1.1.

Key command

[ ] button...Main items
[ ] button...Main items
[ ] button...Sub items
[ ] button...Sub items
[OK] button...Back to main items selection from sub items selection
5.1.2.

Contents of adjustment mode

• Value is shown as a hexadecimal number.
• Preset value differs depending on mode
• After entering the adjustment mode, take note of the value in each item before starting adjustment.
Main item
0A
(SPV7100 PICTURE)
M a i n i t e m
S u b i t e m
S o f t wa r e Ve r si o n
Selection in forward direction and value of sub items change.
Selection in reverse direction and value of sub items change.
Selection in forward direction
Selection in reverse direction
Sub item
R OFFSET
G OFFSET
B OFFSET
R GAIN
G GAIN
B GAIN
516 CONTRAST
516 BRIGHTNESS
516 SATURATION
516 HUE
H PEAK BP GAIN
H PEAK HP GAIN
H PEAK LP GAIN
H PEAK CORING
H PEAK CLIP
V PEAK GAIN
V PEAK CLIP
NR
PHASE
SPV7100 FACTORY MENU
OA OD OE OF
SP V7 1 0 0 PIC TU RE
R O F FSET 0 x 7 A
G O FFSET 0 x 7 A
B O F FSET 0 x 7 A
R G AIN 0x 8 0
G G AIN 0x 8 0
B G AIN 0x 8 0
5 1 6 CO NTRA ST 0x 8 5
5 1 6 BR IG HTNESS 0 x 1 A
5 1 6 SATU RATIO N 0x 9 0
5 1 6 HU E 0x 0 0
H P EAK B P GAIN 0x 0 2
H P EAK H P GAIN 0 x 0 D
H P EAK LP G AIN 0x 0 4
H P EAK C ORING 0x 0 0
H P EAK C LIP 0 x 0 F
V PE AK G AIN 0x 1 8
V PE AK C LIP 0x 1 0
N R OFF
PH A SE 0x 0 0
N TS CM 0 56 A 0 22 0
TH - 3 2 LRTA V3.0 0 9 0 90 1
W T C o de Ve rs ion V3.0
Set R Brightness
Set G Brightness
Set B Brightness
R white-Balance
G white-Balance
B white-Balance
Set_Decoder_Contrast
Set_Decoder_Brightness
Set_Decoder_Saturation
Set_Decoder_Hue
Static gain after BP for Peaking
Static gain after HP for Peaking
Static gain after LP for Peaking
Coring threshold for Peaking
The adjusted threshold for Peaking
Static gain for Vertical Edge Enhancement
Adjusted threshold for Vertical Edge Enhancement
Noise reduction
PLL clock phase
12
Adjustment