Nylon Line Replacement - Echo SRM-280U Operator's Manual

nylon lIne dIsassembly InstructIons
NOTE
For normal use, Speed-Feed
sary. However, if circumstances require disassembly, follow these
instructions.
1. Press top of locking tabs (A) on both sides of Speed-Feed
release cover (B) from eyelet carrier(C).
2. Remove cover from eyelet carrier.

nylon lIne replacement

1. Cut one piece of line to recommended length.
.080 (2.0 mm) dia. – 20' (6 m)
.095 (2.4 mm) dia. – 20' (6 m)
2. Align arrows on top of knob with openings in eyelets.
3. Insert one end of trimmer line into an eyelet, and push line equal
distance through trimmer head.
4. Hold trimmer head while turning knob clockwise to wind line onto
spool until about 5" (13 cm) of each line remains exposed.
t
rImmer head Is now fully loaded and ready for operatIon
IMPORTANT
When the wear indicators located at the bottom of the Speed-Feed
head are worn smooth, replacement of the cover or the entire
Speed-Feed ® head is required.
®
head disassembly is not neces-
G T
rass rimmer
O
peraTOr
®
head to
.
®
Wear
Indicators
/B C
rush uTTer
' m
s anual
C
A
B
Wear
Indicators
29