HOW TO INITIALIZE THE PLASMA DISPLAY
To put the program back at the factory-default,
initialize the Plasma Display as the following
procedure.
1. To turn the power on, press "POWER" button on
the normal remote control unit or the unit.
2. Use the service remote control unit.
3. To enter the service mode, press "SLEEP" button
on the service remote control unit.
4. To reset to factory setting, press "DISPLAY" button
on the normal remote control unit.
- "INITIALIZE" (red) appears on the screen as
shown in Fig. 1.
Ver: Apr 11 2006 (13:00:18)
Boot
[PDP] Push 0 key
System [PDP] Push 0 key
Pic Ver: Apr 11 2006 (13:01:45)
PDP SDI XGA 42 060411 nagoya
Picture
Push 0 key
Submicon Ver: 060214
Calobration chek OK
- After few seconds (completion initialization), col-
or of "INITIALIZE" will change green.
INITIALIZE
Fig. 1
1-7-1
L0700INT