Table of Contents
Advertisement
• Lift radiant plate up & out of left slot (see B) and remove by sliding it out of
right slot (see C).
• Remove burner screw (see B) and remove burner. Check burner for grease
residue or spider webs that may obstruct gas flow. CAUTION: WHEN REPLAC-
ING BURNER, CUT SLOT IN BURNER MUST FACE DOWN.
• To remove liner from outer shell you must disconnect the electrode wire (see
D). First remove the two screws on valve chamber (see D) and remove the
cover plate. Gently pull wire off connector (see D). It is not necessary to
remove electrode from liner.
• Remove Lid and liner by removing hinge screws and lock nuts with 3/16"
hex key wrench (supplied) and 1/2" wrench or pliers. CAUTION: LOCK NUTS
MUST BE INSTALLED WITH LOCKING INDENT MARKS SHOWING (see E).
IMPROPER INSTALLATION WILL DAMAGE THE HINGE SCREW AND LOCK NUT.
• Lift liner out of outer shell by lifting up on liner lip on back side of liner
(see F). When replacing liner, be sure top lip of liner installs over top edge of
outer shell (start with corners of lip and work in).
• Inspect burner, remove any obstructions.
• Clean as indicated in Maintenance (page 6).
• To re-assemble, reverse the procedure.
B
Left
side
slot
Burner screw
E
ELECTRODE SPARK ADJUSTMENT
CAUTION: Spark can cause small shock. Do not leave fin-
gers on or near electrode wire while engaging igniter.
• Electrode wire should be approximately 1/8" from gas
exit hole in burner. Carefully adjust wire if required.
A
DISASSEMBLY & RE-ASSEMBLY
C
Right
side
slot
Locking
Indents
Electrode
Electrode
F
5
Disconnect wire
D
Liner Lip
Liner
Outer Shell
Screws
Advertisement
Table of Contents
