Installation - Rockford Fosgate punch RFP-1403 Installation & Operation Manual

I
NSTALLATION
Since some of these Full Range Speakers are most often used as direct
replacements for stock speakers and are shipped without grilles,
some of the following instructions will not apply. For custom instal-
lations see your Authorized Rockford Fosgate Dealer.
1. Determine where the speakers will be mounted. Ensure an area
large enough for the speaker to mount evenly. Be sure that the
mounting location is deep enough for the speaker to fit; if mounting
in a door, operate all functions (windows, locks, etc.) through their
entire operating range to ensure there is no obstruction.
2. Refer to the specification chart to determine the proper diameter
hole to cut for your speaker model.
3. Using the plastic mounting ring as a template, mark the locations
for the mounting screws. Drill the holes with a 1/8" bit.
4. Slip the screw clips over the holes that were just drilled with the flat
side on the outer face.
5. Feed the speaker wires through the cutout and the plastic mount-
ing ring (from the flat side) and connect to the speaker terminals.
Be sure to observe proper polarity when connecting the wires. The
speaker's positive terminal is indicated with a dot.
6. Fit the ring and speaker to the cutout. Mount them using the
enclosed screws. Fit the grille inside the ring and press gently, but
firmly, into place.
Grille
Screw Clips
Mounting
Ring
Midrange
– 3 –
Cut-Out
Mounting
Hole
I
® ®
N
S
T
A
L
L
A
T
I
O
N