Vpl-Px15 Tool For Writing Network Software - Sony VPL-PS10 Service Manual

2-2-18. VPL-PX15 Tool for Writing Network
Software
There is a tool for upgrading the network software.
Use this tool when upgrading the software in the Windows
CE from the PC card slot.
The OC needs the open space of 32 Mbytes.
How to use :
1. Copy this software to the PC card.
2. Extract the software in the PC card.
(When extracted, a folder containing CEV file and the
version upgrade software is created.)
3. Insert the PC card into the projector and start up the
projector.
Select the INPUT channel for network.
4. Double-click myproject/storage card/CeUpGrade.exe.
5. The dialogue shown in the next page appears. Press the
Browse button and select the CEV file to be upgraded
in the storage card folder.
6. Press the active Upgrade button.
7. The upgrade starts and two progressive bars appr\ear.
The upper bar shows a component in progress. And the
lower bar shows the entire state in progress.
When completed, the menu is once reset and returns to
the initial menu of the network menu.
CE Upgrader v1.0 (Compact Flash Version)
STEP
1. Select CEV File.
2. Push [Upgrade] button.
CEV
Copyright by Sony Corporation 2000-2001; all rights
8. Turn off the projector and on again or select the
Installation Setting in the menu and turn off and on the
input B function to start up.
2-18
Browse...
Upgrade
n
According to the license agreement with Microsoft Co., the
use of software downloaded with this software (upgrade
tool) is exclusively limited to Sony and Service Station
(including Servicing Dealers) with which Sony contracts.
Description
There is a network software upgrade tool "MakeCE.exe".
This software can be used in cases below.
. When replacing the crashed compact flash
. When the file system in the compact flash is destroyed
by turning off the power during the application running
(The symptom : Wherever rebooted, the "Network-
projector" always appears in the center of a picture.)
. When writing the software in the compact flash
. When upgrading
With this tool, the software can be written in the compact
flash (1-796-014-11) on the QC board.
VPL-PS10/PX10/PX15