Lighting & Electronics Houselite Assembly And Operation Manual

Houselite
Lighting & Electronics, Inc.
91 McKinley Street
Market Street Industrial Park
Wappingers Falls, NY 12590
Tel 845-297-1244
Fax 845-297-9270
Info@le-us.com
www.le-us.com
Congratulations on purchasing the LED
Houselite /Worklite
TM
fixture, brace yourself for a whole new world of
convenience and control. With a design incorporat-
ing qualities any application can appreciate, we
present to you a light-weight, compact, customizable
light fixture to serve countless demands.
Houselite /Worklite
TM
The
designed for performance, adaptability and conve-
nience. Already cool-running and versatile, LED
technology continues to improve and provide an
efficient source of light, ready to be worked into your
theatrical or architectural application. Minimum
maintenance and zero lamp replacement makes this
fixture ideal for hard-to-get-to places.
Each fixture includes:
Houselite /Worklite
TM
- LED
- Assembly/Operation Instructions
- Mounting Hardware
/Worklite
TM
TM
. If this is your first LED
TM
is an LED fixture
TM
Fixture
TM
WARNING: Disconnect fixture before any service is
performed. Do not open the fixture while it is still
plugged into the power source.
Assembly Instructions
Clamp Mount:
Materials required:
Houselite
LED
1 -
1 - Standard Theatrical Style Clamp
1 - Cupped Spring Washer
1 - 1/2-13 x 1-1/2 Hex Head Bolt
If the fixture is to be mounted with a clamp, it is attached to
the stud mounted on the top of the driver box by removing
the hex bolt on the bottom of the clamp and then spinning
the clamp onto the stud.
Yoke Mount (Pre-assembled):
Materials required:
Houselite
LED
1 -
1 - Yoke
1 - 5/16-18 Tee Handles
1 - 5/16-18 Hex Bolt
2 - Cupped Spring Washers
2 - Fibre Washers
If the fixture is to be mounted with a yoke, it is attached to
the ends of the driver box using a tee handle on one side and
the hex bolt on the other, cupped washer, and fibre washers
according to the diagram above.
Pendant Mount:
Materials required:
Houselite
LED
1 -
1 - Pendant Pipe
1 - Canopy
2 - Hex Nuts
For pendant mounting, remove the circular cover on top of
the fixture head. Pass the pendant pipe through the hole in
the cover and secure with a hex nut. Thread the cable from
the fixture head through the pipe until it exits the other end.
Insert the pendant pipe through the driver box and secure with
the second hex nut. Make the electrical connection within
the driver box and secure the cover on the head and box.
/Worklite
TM TM
/Worklite
TM TM
/Worklite
TM TM