Advertisement
Operating Instructions
Three basic versions of the LED
Worklite
TM
are manufactured:
1. Version one is the Non-Dimming model of the
fixture. All of the standard attributes of the fixture in
terms of intensity, spread, voltage, wattage, estimated
life and color temperature are identical to the other
two versions with the exception of dimmability.
To operate, plug the fixture into a power source. The
fixture will simply turn on. Unplug the unit from the
power source to turn off. This fixture is not equipped
with control capabilities. (Model number: WKLT/
HSLT-LED-NON-DIM).
2. The second model is the 0-10 volt dimming
version. It has the same features as the non-dim
version but includes the dimming control feature.
Again, all of the standard attributes of the fixture in
terms of intensity, spread, voltage, wattage, estimated
life and color temperature are identical to the other
two versions.
To operate, plug the power cord into the power
source and connect the dimming cable to an appropri-
ate 0-10V dimming module (not included). (Model
number: WKLT/HSLT-LED-DIM).
3. The third model is configured specifically to use
DMX 512 protocol. Again, all of the standard
attributes of the fixture in terms of intensity, spread,
voltage, wattage, estimated LED life and color
temperature are included in this model. In addition,
this version operates on 3 DMX channels allowing
maximum control over the 120 - 1.25w LEDs. The first
channel controls the inner-most two rings of LEDs,
the second channel controls the middle two rings and
the third, the outer-most two rings. This unit also has
power passthru and 5-pin M/F XLR.
To operate, the user can select the channels they
would like to use by manipulating the switches on the
face of the driver box cover. (See the separate
information sheet enclosed for driver specification
and channel setting procedures.) Plug the power
cord into the power source and connect the control
via DMX 5-pin cable to the fixture driver box. Mul-
tiple fixtures can be "daisy chained" together by
plugging the next fixture into the first and continuing
the DMX connection. (Model number: WKLT/HSLT-
LED-DMX512).
Houselite
/
TM
Lamp Addressing - DMX only
Houselite
/Worklite
TM
The LED
three sets of two rings each of LEDs to have a unique
DMX address, allowing for very localized control on a
DMX network. The addressing is completed by
setting the switches on the cover of the driver box
assembly. Addresses can be assigned per seperate
instruction information included with this fixture.
Lamp Replacement
Lamp replacement is not necessary. Your LED fixture
is equipped with LEDs with an expected life of greater
than 50,000 hours. If a LED fails, contact the factory
to determine warranty status and arrange for repair or
replacement.
WARNING:
Do not attempt to repair or replace LEDs.
This action may void your warranty.
©
Copyright 2012 Lighting & Electronics, Inc.
025-0XX [05.31.12] WKLT/HSLT Series
TM
allows for
M
Advertisement
