Advertisement
Wiring Information
Houselite
/Worklite
TM
The LED
are outlined below. The On/Off model is wired very
similarly to the 0-10v fixture. In fact, the same driver is
used in both of those models.
The DMX model contains an internal power supply
unit and a 3 channel driver that passes the DMX
signal and power throughout the LEDs in the fixture.
Both the power and the DMX have parallel passthru
to the next fixture.
On/Off Wire Diagram
0-10V Dimming Wire Diagram
DMX 512 Wire Diagram
TM
wire diagrams
Maintenance
Houselite
/Worklite
TM
LED
The
minimum amount of maintenance. However, ALL mainte-
nance must be performed by qualified personnel only!
WARNING:
Disconnect fixture before any service is
performed. Do not open the fixture while it is still
plugged into the power source.
WARNING:
Do not open the head of the fixture that
consists of the LEDs, lenses, glass cover and heatsink.
Trying to perform maintenance on these components may
void your warranty.
Some simple checks should be made:
1. Remove dust that may collect from the baffles on the
heatsink. Over time the collection of dust may inhibit the
cooling capacity of the heatsink. A simple dusting can
ensure proper cooling.
2. Hardware must be checked, wire connections tightened
and electrical insulation inspected for damage.
3. The LED driver and power supply should be inspected
and may require replacement periodically. Both of these
components are located in the driver box that is either
attached to the top of the fixture or has been remoted from
the fixture.
To ensure against future hazards, any wear detected must be
reversed either by repair or replacement. It is the equipment
user's responsibility to keep the equipment in proper, and
safe, working condition.
Ensure fixtures are properly secured to their means of
support. Fixtures hanging for extended periods should be
checked periodically. IMPORTANT: Underwriters
Laboratories (UL) requires that an approved safety cable be
employed when portable stage and studio lighting equipment
is used in a suspended position.
This equipment was created to be used in
compliance with the NEC and local codes.
Any modification to, or misuse of this fixture
will void any warranty or liability claims
either explicit or implied. It is the responsibil-
ity of the user to be sure this unit is used in
compliance with the NEC and local codes.
TM
requires a
NEC and
are registered
trademarks of the National Fire
Protection Association (NFPA).
Advertisement
