Chevrolet Silverado 2015 Owner's Manual page 116

Example Rear Driver Side
Position
2.1. For a top tether in the rear
driver side position:
2.1.1. Raise the headrest.
2.1.2. Route the top
tether (4) between
the headrest posts,
through the loop (3),
behind the inboard
headrest post, and
under the center
shoulder belt (2).
2.1.3. Then attach the top
tether (4) to the top
tether
anchor (loop) (1) at
the center rear
seating position.
2.2. For a top tether in the rear
center position:
2.2.1. Route the top
tether (4) through the
center loop (1), and
behind the
passenger side
headrest post.
2.2.2. Then attach the top
tether (4) to the top
tether anchor (loop)
at the rear
passenger side
seating position.
2.3. For a top tether in the rear
passenger position:
2.3.1. Raise the headrest.
2.3.2. Route the top
tether (4) between
the headrest posts,
Seats and Restraints
through the loop on
the passenger side
and behind the
inboard
headrest post.
2.3.3. Then attach the top
tether (4) to the top
tether
anchor (loop) (1) at
the center rear
seating position.
3. Tighten the top tether per the
child restraint manufacturer's
instructions.
When the top tether is properly
tightened, the anchor (loop) may
bend. This is normal and will not
damage the vehicle.
If child restraints are installed in
both outboard positions, both top
tethers can be attached to the
center loop. Top tethers can be
attached for child restraints in all
three rear seating positions at
the same time, following the
routing instructions above.
3-53