Table of Contents
Advertisement
Setup
Unfolding the Handle
1. Raise the handle to the operating position.
2. Slide the oval locking rings down each side of the
upper handle over the lower handle, locking the
handle sections together.
Filling the Crankcase with Oil
The engine crankcase is shipped without oil. You
must fill it with approximately 22 ounces (0.65 l) of oil
before starting the engine. Refer to Checking the Engine
Oil Level in Checking the Engine Oil Level (page 8), for
oil specifications and instructions.
g013073
1
Figure 4
Product Overview
6
5
4
3
2
1
1. Fuel shut-off valve
2. Air cleaner
3. Spark plug wire
4. Engine On/Off switch
(on the right side of the
engine)
5. Recoil starter
6. Fuel tank
7. Rear weights
8. Handle
Controls
Recoil Starter
Pull the recoil starter handle to start engine (Figure 5).
Fuel Shut-off Valve
Close the fuel shut-off valve when transporting or
storing the machine (Figure 5).
Engine On/Off Switch
Toggle the engine on off switch to On to enable the
engine electrical system so that it can be started. Switch
it to Off to stop the engine.
Throttle Lever
Before starting a cold engine, move the throttle lever
forward to the Choke position. After the engine starts,
pull the throttle lever back to the Fast position.
7
9
8
7
15
g013072
Figure 5
9. Traction control lever
10. Throttle lever
11. Tine control lever
12. Oval handle locking ring
13. Coring depth, wheel stop
14. Tie-down/lift loops
15. Tines
10
11
12
13
14
Advertisement
Table of Contents
