Advertisement
Software upgrade will take 5 minutes
Do not switch off!
Package version:
000025.0
Software BE
Completed
Software FE
Completed
Software MCU1:
Not started
Software Dock:
2%
Software MCU3:
Not started
Software upgrade will take 5 minutes
Do not switch off!
Package version:
000025.0
Software BE
Completed
Software FE
Completed
Software MCU1:
1%
Software Dock:
Failed
Software MCU3:
f) The set will shut down automatically when the software upgrade
is completed.
6) How to replace the defective Blu-ray Loader
a) Remove the defective Blu-ray Loader.
b) Remove the shield cover at the top of Blu-ray Loader as shown
below.
2 - 2
c) Assembly Blu-ray Loader to connect "J509","J507","HA801" on
the top of BD Board as shown below.
d) Remove soldered joint on the ESD protection points.
The ESD protection points
on the top of board
The ESD protection points
on the top of board
Top side view of OPU
Bottom side view of OPU
Note: The 2 ESD protection points on any one side must be
soldered if
o the Blu-ray Loader is OK and needs to be disconnected
from connector J509, J507 and HA801 of the BD Board.
o the defective Blu-ray Loader is needed to be send back to
supplier for failure analysis and to support backcharging evidence.
7) Produce to change Tuner grid (only for /51 version)
In some countries, you can switch the FM tuning grid between 50
kHz and 100 kHz. Changing the tuning grid erases all preset radio
stations.
a) Press<Radio> button on R/C
b) Press <Stop> button on R/C.
c) Press and hold <Play> until (50 kHz) or (100 kHz) is displayed.
Note: repeaing the same action will toggle back to it previous
tunning grid setting.
8) OSD Language setup (only for 51 version)
a) Press "
" <Home> button on R/C.
b) Select <Setup>, then press "OK" button on R/C.
c) Select <Preference>, then press <OK> button on R/C.
d) Select <Menu language>, then press <OK> button on R/C.
C) Select <English>, then press <OK> button on R/C.
2 - 2
CAUTION!
This information is confi dential and may not be
distributed.Only a qualifi ed service person should
reprogram the Region Code.
Advertisement
