Reviewing The Programme Times; Modifying The Programme - Honeywell ST9100C User Manual

reviewing the Programme Times

To review your programme, move the slider to the PrOGrAmme position.
To review the programme times, press the
ON and OFF markers will be displayed to show you which time is being reviewed.
Any of these times can be adjusted by using the
confirmed using the
after reviewing is complete.

modifying the Programme

The programme has three pairs of ON/OFF switching times per day. Each time can
be set between 3.00 am and 2.50 am (on the next day) to allow you to programme
the system to stay on past midnight, if required.
a. Move the slider to the PrOGrAmme position. 'SET PROGRAMME' will show
briefly to verify this action.
DAY/TIME
PROGRAMME
RUN
b. 'SET ON-TIME 1' will then be displayed and the time setting for the first ON 1
time for mONDAY will now be flashing to indicate it can be changed. If you do
not wish to change the time, press the green
step. If you do wish to make a change, use the
the first ON 1 time. Each press of the button will change the time by 10 minutes.
As soon as the time has been changed, the message 'ON-TIME 1 OK?' will be
displayed. Press the green
the next step. 'SAVED' will be displayed for a moment to confirm that any change
has been saved to memory.
PrOGrAmmING YOUr ST9100C
button. Remember to return the slider to the rUN position
button to confirm the time is correct and move to
button repeatedly. The appropriate
or buttons, and then
button and move to the next
or buttons to change