Air Pressure Gauge And Compressor Controls - Motor Trike GL1800 SPYDER / 2+2 Service Manual

From the solenoid switch the air line is (usually) wrapped in tape with two wires, and is routed along the
inside of the frame up to and under the Top Shelter, and behind the Shelter to the Right pocket latch
panel. To access the compressor control switch, and air lines behind the panel follow this procedure to
remove the panel, and check the air line connections.

Air Pressure Gauge and Compressor Controls

Number 1: Air line and wires from Low Pressure Solenoid Switch.
Number 2: Compressor control panel Air Manifold
Number 3: Air Release Valve connection.
Number 4: Air connection on rear of Air Pressure Gauge.
1. Remove any attachments that may be installed on the faring. Carefully remove the trim
piece along the side of the Right pocket. This is easily accomplished buy carefully inserting a
small flat screwdriver on the inside portion of the trim piece at the bottom, and lift it up to
release the tab. With your fingernails you can continue releasing the tabs up to the top.
Carefully rock the trim piece away from the faring to remove it.
Low Pressure Solenoid Switch.
Air Pressure Gauge and Compressor Controls.