Test Operation - Fast TR7DRH Installation Instructions Manual

STEP #4
Turn the power on to the Heating/Air
6 00 : 70
7 2 o
Am
Su
Cooler Mode Warmer
Conditioning system.
Press the MODE button repeatedly until
6 00 : 70
7 2 o
Am
Su
the COOL icon appears on the display.
Cooler Mode Warmer
Press the up/down buttons until the set
temperature is 10 degrees below room
temperature. The air conditioner should
turn on. NOTE: Most equipment has a
time delay of 5 minutes between cool
cycles. This feature is defeatable on the
thermostat. Consult the Owner's Manual
under Setup, cycles per hour.
Press the MODE button repeatedly until
: 70
6 00 7 2 o
Am
Su
the HEAT icon appears on the display.
Cooler Mode Warmer
Press the up/down buttons until the set
temperature is 10 degrees above room
temperature. The furnace should turn on.
Create a heat demand by following the
: 70
6 00 7 2 o
Am
Su
prior step to test heat operation.
Cooler Mode Warmer
Press the Humidity Shift button so the
the Humidity icon appears on the display.
Press the up/down buttons until the
humidity setpoint is 10% above the room
humidity
The humidifier should turn on.

TEST OPERATION

Page 8