Advertisement
Harmony Remote User Manual
Customizing your Harmony Remote
All customization of your Harmony Remote is done from your Member Home Page.
To add or remove an Activity, click on "Add an Activity" or "Remove an Activity".
l
To change an Activity you have already set up, click on "Edit this Activity" next to the Activity
l
icon, and then clcik on the appropriate option.
To add or remove entertainment devices, click on "Add a Device" or "Remove a Device".
l
To change a device you have already set up, click on "Edit this device" next to the Device icon,
l
and then click on the appropriate option.
You can see the Activity Id, or a Device Id, by "hovering" your mouse cursor over the
Activity icon or device icon.
You can change the function of buttons within a particular Activity and mode. From your
Member Home Page, click on "Edit this Activity" next to the Activtiy icon, and then click on
"Change a Button's function or behaviour for this Activity".
Teaching Infrared Commands
The Harmony Remote will learn infrared commands from other remote controls. This is important in
situations where the HarmonRemote.com infrared database does not already contain an infrared
command you would like to use.
Determine which device you would like to send the infrared command to. click on "Edit this
device" next to the Device icon, and then click on "Learn infrared commands".
Setup
The Harmony Remote has an infrared sensor in a small slot as shown in the picture on the left. It is
important that the remote that you wish to learn the infrared command from is placed pointing at the
infrared sensor on the Harmony Remote. The other end of the Harmony Remote should be plugged
into the USB cable. The remote controls should be about 2 to 4 inches apart as shown in the picture
below.
If the web site says that there were problems reading the infrared signal, try moving the
original remote control further from your Harmony Remote and try again. If that does not
work, try again with your original remote control closer to the Harmony Remote.
March 25, 2003
Advertisement
