Panasonic UF-790 Operating Instructions Manual page 38

Customizing Your Machine
Fax Parameter Table
No. Parameter
34 ENERGY SAVER
35 DAYLIGHT TIME
36 RING PATTERN
DETECT (DRD)
(See Note 2)
37 RCV TO MEMORY
38 ACCESS CODE
39 PIN CODE ACCESS
42 CONF. POLLED FILE
43 PASSWORD-XMT
44 PASSWORD-RCV
46 SELECT RCV
47 REMOTE RECEPTION
38
Setting
Number
1
MODE
2
*3
1
*2
*1
2
*1
2
3
*1
SAVE
2
*1
2
*1
2
*1
2
1
*2
Setting
Off To reduce the power consumption in standby, select either
Energy-Saver or Sleep mode and specify the Delay Time
Energy-
(1 to 120 minutes) for the machine to enter into the
Saver
selected mode.
Sleep
The Delay Timer setting is only available in the Energy-
Saver or Sleep Modes.
Off
Energy-Saver Mode : Saves energy by consuming less
Sleep Mode
Invalid Selecting whether the clock adjusts for Daylight Saving
Time automatically. The built-in clock will advance 1 hour
Valid
at 2:00 am on the first Sunday in April and fallback 1 hour
at 2:00 am on the last Sunday in October.
Invalid All ring patterns.
Valid Select a ring pattern for automatic answering.
1: A Standard ring pattern.
2: B Double ring pattern.
3: C Triple ring pattern (Short-Short-Long).
4: D All other triple ring patterns, except the
type C described above.
(----) Enter a 4-digit password used to print out the received
document in memory by using F8-5 (RCV TO MEMORY).
When F8-5 is set to On, this parameter will not be shown
on the LCD display. (See page 92)
(----) Enter a 4-digit Access Code to secure the machine from
unauthorized use. (See page 90)
None Selecting the access method (Prefix or Suffix) to dial a
number with PIN Code. (See page 97)
Suffix
Prefix
Invalid Selecting whether the machine saves the confidential
polled file even after the file is polled once.
Valid
Off Setting a 4-digit XMT-Password and selecting whether the
machine performs and checks the XMT-Password of the
On
receiving station when transmitting. (See page 102)
Off Setting a 4-digit RCV-Password and selecting whether the
machine performs and checks the RCV-Password of the
On
transmitting station when receiving. (See page 103)
Invalid Selecting whether the machine performs selective
reception. (See page 100)
Valid
Invalid Selecting whether or not the machine accepts remote
reception command. (See page 63)
Valid
Comments
: The unit will remain in standby
mode and consume more energy
than when in Energy-Saver or
Sleep modes.
power than when in standby mode
by turning off the fuser unit after
the specified time.
: This is the lowest power state that
the machine enters after the
specified time without actually
turning off.