Honda 2006 Civic Owner's Manual page 127

Main Menu Main Menu
Table of Contents
SCAN The scan function gives
you a sampling of all channels while
in the channel mode. In the category
mode, only the channels within that
category are scanned. To activate
scan, press the SCAN button. The
system plays each channel in
numerical order for a few seconds,
then selects the next channel. When
you hear a channel you want to
continue listening to, press the
button again.
Preset You can store up to 12
preset channels using each side of
the preset button. Each side of the
button stores one channel from the
XM1 band and one channel from the
XM2 band.
To store a channel:
1. Press the XM button. Either XM1
or XM2 will show in the display.
Audio System (Models without navigation system)
2. Use the tune, seek, or scan
function to tune to a desired
channel.
In category mode, only channels
within that category can be selected.
In channel mode, all channels can be
selected.
3. Pick a preset number you want for
that channel. Press and hold the
button until you hear a beep.
4. Repeat steps 2 and 3 to store the
first six channels.
Press the XM button again. Store
5.
the next six channels using steps 2
and 3.
Once a channel is stored, press and
release the proper side of the preset
button to tune to it.
XM Radio Display Messages
XM is loading the
''LOADING''
audio or program information.
''OFF AIR'' The channel
currently selected is no longer
broadcasting.
''UPDATING'' The encryption
code is being updated. Wait until the
encryption code is fully updated.
Channels 0 and 1 should still work
normally.
''NO SIGNAL'' The signal is
currently too weak. Move the vehicle
to an area away from tall buildings,
and with an unobstructed view of the
southern horizon.
CONTINUED
123