Yamaha YDRE Owner's/Operator's Manual page 35

MAINTENANCE
1
2
3
4
5
6
7
8
9
10
11
8-9
Transaxle Oil
To check transaxle oil level:
1. Place the golf car on a flat, level
surface.
2. Remove seven plastic rivets 1
and two bolts 2, and remove the
bag holder insert 3.
3. Place an oil pan under the
transaxle case.
4. Clean area around servicing plug 4.
5. Using an 8 mm hex wrench,
remove transaxle oil servicing
plug located on the rear of the
Y-1994
transaxle case.
6. Transaxle oil should be at the top
of the oil servicing hole or just
beginning to run out of hole.
NOTICE
Do not allow foreign material to
enter transaxle. Serious transaxle
damage can result.
7. If needed, add Yamalube Friction
Y-1214 Modified Shaft Drive Gear Oil
until it is at the top of the plug
hole or just beginning to run out
of servicing hole.
TIP
The YDRE Golf Car is equipped with
an internal wet brake. Use of oil other
than Yamalube Friction Modified
Shaft Drive Gear Oil will cause brake
noise.
8. Install the transaxle servicing
plug and tighten to 14-19 Nm,
1.4-1.9 m•kg (120-168 in•lb).
9. Install the bag holder insert
3 and secure with two bolts 2
and seven plastic rivets 1.
JW9