Yada YD-V9 User Manual page 8

B. Pairing/Linking
Pairing Bluetooth enabled mobile phones with the YD-V9
®
Speakerphone authorizes hands-free communication. This
step only needs to be performed once.
Before Pairing the YD-V9 Speakerphone:
• Ensure the YD-V9 is plugged directly to a 12V power port
• Ensure the YD-V9 is OFF
• Ensure the Bluetooth on your mobile phone is activated
®
Follow the steps below to pair your YD-V9 with your mobile
phone:
• Press and hold red button for 7-8 seconds
• Release the button until the LED indicator alternately blinks
red and blue
NOTE: YD-V9 is now in pairing mode
• Activate the Bluetooth
®
NOTE: The following steps are general procedure; to access
Bluetooth Menu for you mobile phone, please refer to your
®
phone user manual.
• Select SET-UP or CONNECT from your mobile phone
menu
• Find and select OPTION to discover Bluetooth
establishing a connection may take several minutes
• If found, phone display should indicate YD-V9 device was
detected or Select "YD-V9" from the list
• Phone should give you a prompt asking if you want to pair
the device
• Select OK or ACCEPT and wait for prompt to enter passkey
or PIN
• Enter the code 0000
• Select "OK" to pair and connect the YD-V9 and the
handset
7
settings of your mobile phone
®
NOTE: If the YD-V9 and mobile handset did not successfully
pair, follow the steps below to retry pairing:
• Turn the YD-V9 OFF
• Turn OFF all other Bluetooth
pairing process
• Repeat the pairing instructions from the beginning
NOTE:
• After 2 minutes, the YD-V9 will exit paring mode
automatically if it can't connect with the mobile phone
devices;
devices before starting the
®